Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Custom Device Name
Net-X II a custom device name, do the following:
To assign the
1.
Use the knob to select 1.Custom Device Name.
2.
Press the knob.
3.
If there is no name set for this product, press the knob. If there is a name set for this product, use
the knob to select which letter to edit, then press the knob.
4.
Use the knob to select the letter, number or symbol, from A–@. There are 63 options.
5.
Repeat until the name is set as desired.
6.
Use the knob to select either Enter to save the name, or Cancel to exit without saving.
7.
Press the knob.
Set IP Mode
The Net-X II can use a pre-set static IP address, or it can be set manually.
Static IP
To set the Net-X II to a pre-set static IP address, follow the instructions below:
1.
Use the knob to select 2.Set IP Mode.
2.
Press the knob.
3.
Use the knob to select 1.Static IP.
4.
Press the knob.
Manual IP
To set the IP address manually, do the following:
1.
Use the knob to select 2.Set IP Mode.
2.
Press the knob.
3.
Use the knob to select 2.Manual IP.
4.
Press the knob.
5.
The manual IP address can be set from 000.000.000.000 to 255.255.255.255 by using the knob
to scroll and select the desired numbers 000-255 for each byte (set of three numbers). Use this
process to set each of the four bytes.
6.
Use the knob to select Enter to save the chosen IP address or Cancel to exit without saving.
Net-X II User Manual Rev. 2
12
Publicidad
Tabla de contenido
