Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Net
To set the net setting, do the following:
1.
Select the DMX port to configure as instructed in
2.
Use the knob to select 3.Net.
3.
Press the knob.
4.
Use the knob to select from 000-127.
5.
Press the knob
LCD Backlight
To set the amount of time after inactivity before the display backlight turns off, follow the instructions below.
1.
Use the knob to select 6.LCD Backlight.
2.
Press the knob.
3.
Use the knob to select from the following options, 1.On (does not turn off), 2.10 Seconds (turns
off after 10 seconds of inactivity), 3.30 Seconds (turns off after 30 seconds of inactivity), or 4.Exit
(to cancel).
4.
Press the knob.
User Preset
This option saves 4 different preset menu option configurations. To set these presets, follow the
instructions below.
1.
Use the knob to select 7.User Preset.
2.
Press the knob.
3.
Use the knob to select one of the four following presets:
•
1. Art-net 8-port DMX (Sets all 8 ports to receive 8 universes of ArtNet from 0-7).
•
2. sACN to 8-port DMX (Sets all 8 ports to receive 8 universes of sACN from 1-8).
•
3. 1x8 DMX Splitter (Sets the product to operate as a DMX splitter with all 8 outputs
receiving DMX from input A).
•
4. 2x4 DMX Splitter (Sets 1–4 outputs to input-port A and the 5–8 outputs to input-port B).
•
5.Exit (to cancel).
4.
Press the knob.
Factory Reset
To restore the Net-X II to factory default settings, do the follow:
1.
Use the knob to select 8.Factory Reset.
2.
Press the knob.
3.
Use the knob to select NO (do not reset) or YES (reset to factory settings).
4.
Press the knob.
Record Scenes
The Net-X II has the capability to record up to 10 scenes. To record scenes, follow the instructions below.
1.
Use the knob to select 9.Record Scenes.
2.
Press the knob.
3.
Use the knob to select from Scene 1–10.
4.
Press the knob.
Scene Name
The Net-X II allows you to customize the name of each scene. To name a scene, do the following:
1.
Select the Scene to configure as instructed in
2.
Use the knob to select 1.Name:Scene_1-10.
3.
Press the knob.
4.
Use the knob to select the letter, number or symbol, from A–@. There are 96 options.
5.
Repeat until the name is set as desired.
6.
Use the knob to select either Enter to save the name, or Cancel to exit without saving.
7.
Press the knob.
Net-X II User Manual Rev. 2
DMX Port
Settings.
Record
Scenes.
14
Publicidad
Tabla de contenido
