Troubleshooting Chart; Specifications - MTD Pro Dassault Rafale M Manuel Del Dueño

CUTTING ATTACHMENT WILL NOT ADVANCE LINE
CAUSE
Cutting attachment bound with grass
Cutting attachment out of line
Inner reel bound up
Cutting head dirty
Line welded
Line twisted when refilled
Not enough line is exposed
CUTTING LINE ADVANCES UNCONTROLLABLY
CAUSE
Oil, cleaner or lubricant in cutting head
For engine service and warranty please call 1-800-426-7701
to locate the closest service dealer in your area.
DRIVE SHAFT AND CUTTING ATTACHMENT*
Drive Shaft Housing ........................................................................................................................................................... Aluminum Tube
Throttle Control............................................................................................................................. Finger-Tip Trigger w/Momentary Switch
Approximate Unit Weight (No fuel, with cutting attachment, shield and D-handle) ............................................................ 13 lbs. (5.9 kg)
Cutting Mechanism.............................................................................................................................................. Dual String Cutting Head
Line Spool.................................................................................................................................................................... Bump Line Releaser
Line Spool Diameter ................................................................................................................................................... 4 inches (101.6 mm)
Trimming Line Diameter......................................................................................................................................... 0.105 inches (2.67 mm)
Cutting Path Diameter ............................................................................................................................................... 17 inches (43.18 cm)
TROUBLESHOOTING
Stop the engine and clean cutting attachment
Refill with new line
Replace the inner reel
Clean inner reel and outer spool
Disassemble, remove the welded section and rewind
Disassemble and rewind the line
Push the bump knob and pull out line until 4 inches
(102 mm) of line is outside of the cutting attachment
Clean and thoroughly dry the cutting head
For boom service and warranty please call 1-800-800-7310

SPECIFICATIONS

7
ACTION
ACTION