Insert The Batteries - Xavax Picta Manual Del Usuario

4. Controls and Displays
• UNIT button: for selecting the units of weight:
kilograms (kg), pounds (lb) or stones (st:lb)
• Time display
5. Getting Started

5.1 Insert the batteries:

• Use a PCS CR2032 coin cell battery.
• To change the battery, open the battery cover
on the back of the device, insert a CR2032
battery with the correct polarity into the battery
compartment. Close the battery compartment fully
Note
• Before using the scales for the first time
or after moving the scales they must be
restarted. Without restarting them, the
measurements could be incorrect.
6. Operation
• Place the scale on a clean and level surface.
• Ensure that the scale is
Weighing:
• The scale switches on automatically when you
step on it. Your body weight flashes on the
display during the weighing process.
• Wait until the displayed weight stops flashing.
Once the weight has stabilised, it is displayed for
another ten seconds.
• The scale then switches off automatically
Error messages
• The error message "Err" is displayed when the
scale is overloaded.
• The message "LO" indicates that the battery
is nearly dead. Replace the battery as soon as
possible.
095306man_cs_de_el_en_es_fi_fr_hu_it_nl_pl_pt_ro_ru_sk_sv_tr.indd 3
stable.
Note
• To ensure accurate measurements, we
recommend that you weigh yourself at the
same time each day (e.g. in the morning right
after you wake up)
Note
• When the weight displayed by the scales
seems to be incorrect, check that the contact
between battery and the contacts is in proper
working order. If you haven't used the scales
in a long time, change the battery and try
again
7. Setting the time
To set the time, remove the battery briefly and then
reinsert it. Once you have inserted the battery in the
scales, the time flashes "12:00" in the display. You
can now set the correct time using the "kg/lb/st"
button on the back of the scales. Press the button
repeatedly to set the hour to the correct time. Once
you have reached the correct hour, press and hold
the button for approximately 5 seconds to confirm.
At this point the minutes will begin flashing. Press
the button again to set the minutes to the correct
time and then press and hold for approximately
5 seconds to confirm. The time is continuously
displayed in standby mode.
8. Integrated picture frame
A picture frame is integrated into the surface of
the scales. The insert can be removed and replaced
with your own photos, drawings, collages, etc.
Open the plastic cover on the back of the scales by
pulling the two clips upwards. You can then remove
the plastic cover and replace the insert. Insert size:
up to 24.50 cm x 19.50 cm
3
21.10.13 10:4