Safety Alert Symbol; Specifications - BriskHeat SDC Manual De Instrucciones

SAFETY ALERT SYMBOL

The symbol above is used to call your attention to instructions concerning your personal safety. It points out important
safety precautions. It means "ATTENTION! Become Alert! Your Personal Safety is
that follows and be alert to the possibility of personal injury or death.
Immediate hazards which WILL result in severe
personal injury or death.
Hazards or unsafe practices that COULD result in
severe personal injury or death.
Hazards or unsafe practices that COULD result in
minor personal injury or property damage.

Do not immerse or spray any component of the
temperature controller in liquid.

Keep volatile or combustible material away from
controller when in use.

Keep sharp metal objects away from controller.

If the equipment is used in a manner not specified
by the manufacturer, the protection provided by
the equipment can be impaired.

The unit must be connected to Protective Earth
Grounding.
Failure to observe these warnings may result in electric
shock, risk of fire, and personal injury or death.
End User Must Comply with the Following:

Only qualified personnel are allowed to connect electrical wiring.

All electrical wiring must follow local electrical codes and NEC Article 427.

The person who performs the final installation / wiring must be qualified for this work.

The end-user is responsible for providing a suitable disconnect device.

The end-user is responsible for providing a suitable over-protection device. It is highly recommended that a
ground-fault circuit breaker be used.
®
© BriskHeat Corporation. All rights reserved.
SDC Benchtop Digital Temperature Controller
involved!" Read the message
A person who has not read and understood all
operating instructions is NOT qualified to operate this
product.

Inspect all components before use.

Do not use controller if any component is
damaged.

Do not repair a damaged or faulty
controller.

Do not crush or apply severe physical stress on
any component of system, including cord
assembly.

Unplug controller when not in use.

Only use power cords provided by
BriskHeat®.

Unit must be mounted away from vibration,
impacts, water and corrosive gases.

The box containing the controller should be stored
indoors in a dry, protected area. Under no
circumstances should condensation, rain, snow or
water be allowed to come in contact with the box
or the controller while in storage.
Failure to observe these warnings may result in
personal injury or damage to the temperature
controller.
3
ATTENTION
For best accuracy of temperature measurement, do not install probe cable near power cables.

SPECIFICATIONS

Input Type
°C
J-type Thermocouple (P5) 0 - 700°C
K-type Thermocouple (P5) 0 - 999°C
S-type Thermocouple (P5) 0 - 999°C
Conditions
Storage Temperature (-)20 to 80°C
Temperature Limits: Ambient 0 to 80°C
Weight
Output 16A SPDT relay @ 250VAC resistive
Horsepower Rating
Control Type
Power Requirements
12VAC/VDC or 24VAC/DC
Display 3-digit, red, 1/2" (12.7mm) digits, plus sign
Resolution
Memory Back-up
NOTE:
The SDC comes with input power fuses of 100mA fast-acting 250VAC rating for the control
circuit.
®
© BriskHeat Corporation. All rights reserved.
SDC Benchtop Digital Temperature Controller
Up button
Down button
Set button
Display
Temperature Range
Accuracy
°F
32 - 999°F ±1% FS
32 - 999°F ±1% FS
0 - 999°F ±1% FS
(-)4 to 176°F
32 to 158°F
2.3 oz (65 g)
1 HP
ON/OFF
110VAC, 230VAC,
1°
Nonvolatile
4