3M 82-B1 Guia De Inicio Rapido página 3

5.0 Install Mold Body
5.1 Trim mold ends with knife to fit cable slightly loose.
Hold mold halves in place, centered over splice, snap
mold halves together firmly. Check to see that both seams
are carefully snapped together. Tape ends of mold body
around cable to seal. Use Scotch™ 23 Electrical Tape
supplied with kit. See Figure 3.
Note: Stretch tape to 3/4 original width.
5.2 Put pouring spouts in holes. See Figure 4.
6.0 Pour Splice
6.1 Position splice level. Mix resin thoroughly per
instructions on resin package. Pour resin immediately
after mixing. Fill mold through one spout until both
spouts are completely filled. See Figure 5. Refill spout
after air escapes.
6.2 When resin has solidified and cooled, splice may be put
into service. Clip off spouts if desired. See Figure 6.
Figure 5
Figure 3
Figure 4
Figure 6