Wiring Instructions - Ecco 6221000 Serie Instrucciones De Instalacion Y Uso

Wiring Instructions:

Notes:
1. Larger wires and tight connections will provide longer service life for components. For high current wires it is highly
recommended that terminal blocks or soldered connections be used with shrink tubing to protect the connections.
Do not use insulation displacement connectors (e.g., 3M Scotchlock type connectors).
2. Route wiring using grommets and sealant when passing through compartment walls. Minimize the number of
splices to reduce voltage drop. High ambient temperatures (e.g., under-hood) will significantly reduce the current
carrying capacity of wires, fuses, and circuit breakers. All wiring should conform to the minimum wire size and other
recommendations of the manufacturer and be protected from moving parts and hot surfaces. Looms, grommets,
cable ties, and similar installation hardware should be used to anchor and protect all wiring.
3. Fuses or circuit breakers should be located as close to the power takeoff points as possible and properly sized to
protect the wiring and devices.
4. Particular attention should be paid to the location and method of making electrical connections and splices to
protect these points from corrosion and loss of conductivity.
5. Ground termination should only be made to substantial chassis components, preferably directly to the vehicle
battery.
6. Circuit breakers are very sensitive to high temperatures and will "false trip" when mounted in hot environments or
operated close to their capacity.
Important:
Disable power before wiring up the bar.
The wiring for the strobe bar is as shown in Figure 3 below.
All wiring should be a minimum of 18AWG. The positive
line must have a 10 amp fuse. A switch may be used to
control the on/off function.
FUSE (10 AMP)
(USER SUPPLIED)
920-0014-00 Rev. C
SWITCH
(USER SUPPLIED)
GROUND
Figure 3
Important!
This unit is a safety device, and it must be
connected to its own, separate fused power point to
assure its continued operation should any other electrical
accessory fail.
RED
ORA GRN
ORANGE WIRE:
BLACK
GREEN WIRE:
GROUND
NO CONNECTION = DOUBLE FLASH
GROUNDED = QUAD FLASH
NO CONNECTION = HIGH INTENSITY
GROUNDED = MED. INTENSITY
Page 3 of 5