Wiring-Wall Control; Canopy Assembly - Craftmade Teana Guia De Instalacion

7. Wiring - Wall Control
Remove existing wall switch. Wire the wall
control as shown in diagram at right.
Connect BLACK/WHITE wire from wall control
to BLACK (AC IN L) wire in outlet box. Connect
BLACK wire from wall control to BLACK (AC IN
N) wire from fan (inside the outlet box).
Connect BLUE wire from wall control to BLUE
wire from light in the outlet box.
GREEN/YELLOW ground wire from wall control
to ground wire in the outlet box.
connectors provided when making
connections.
*Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently push wires and taped wire connectors
into outlet box.
Attach wall control to outlet box and secure
with screws from original wall switch. Attach
plate (included) to wall control using 2 screws
provided with the wall control.

8. Canopy Assembly.

Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened
screw in hanging bracket and push up. Twist
canopy to lock. Re-insert screw that was removed
and then tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
outlet box
Connect
Use wire
(wiring for wall control)
page 7
BLACK
BLACK/WHITE
(AC IN L)
BLUE
BLUE
green/
GREEN/
bare
YELLOW
ground
wall control
BLACK
BLACK
(AC IN N
from fan)
screw
canopy
canopy cover
plate
screw
plate
hanging bracket
screw