Cleaning And Applying Detergent - Briggs & Stratton 020275 Manual Del Operario

2. Select desired Project Pro® nozzle:
• For delicate rinse (lower pressure and higher flow),
for gentle cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc., select yellow
Delicate Project Pro® nozzle.
• For general rinsing (medium pressure and medium
flow), ideal for most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc., select orange
General Project Pro® nozzle.
• For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains,
rust removal or other stubborn substances (tar,
gum, grease, wax, etc.), select red Max Project
Pro® nozzle.
• For applying detergent, applies project specific
cleaners to help break down stubborn dirt and
grime on a variety of surfaces, select black Project
Pro® cleaning detergent nozzle.
3. Pull back on collar, insert new Project Pro® nozzle and
release collar. Tug on Project Pro® nozzle to make sure
it is securely in place.
Usage Tips
• For most effective cleaning, keep nozzle from 8 to
24 inches (20 to 61 cm) away from cleaning surface.
• If you get nozzle too close, especially using a high
pressure nozzle, you may damage surface being
cleaned.
• DO NOT get closer than 6 inches (15 cm) when
cleaning tires.

Cleaning and Applying Detergent

CAUTION
Chemicals can cause bodily injury, and/ or property
damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
To apply detergent, follow these steps:
1. Review use of Project Pro® nozzles.
2. Prepare detergent solution as required by job.
3. Place small filter end of detergent siphoning tube into
detergent container.
NOTICE
Contact with the hot muffler can damage detergent
siphoning tube.
• When inserting the filter into a detergent solution bottle, route
the tube so as to keep it from inadvertently contacting the hot
muffler.
NOTE: Make sure the filter is fully submerged in detergent
while applying detergent.
4. Make sure black detergent nozzle is installed.
NOTE: Detergent cannot be applied with the high pressure
Project Pro® nozzle (Orange, Yellow or Red).
17