in-lite CLASSIQ Manual De Instrucciones página 9

GB
Connection of the fixture to 100-240V
The appliance should only be connected to a 100-240V power source
by an authorised installer. Follow the steps below to install the fitting
correctly:
Step 1
Using a soft cloth place the lamp in the fitting of the fixture. Avoid
direct contact with the lamp; grease and salts from the skin can
considerably shorten the service life. Then attach the top of the fixture
using the Allen bolts.
Step 2
Before attaching the fixture make a hole through the wall.
Step 3
Feed the 100-240V power cable through the hole (Fig. 1) and connect
the cable to the fitting using the connecting block. Make sure the
screws are properly tightened.
Step 4
Use the screws provided to attach the fixture.
Replacing the lamp
Caution! Before replacing the lamp it should have been switched off
for a minimum of 10 minutes to allow it to cool. Then use a soft cloth to
replace the lamp. Avoid direct contact with the lamp; grease and salts
from the skin can considerably shorten the service life. To replace the
lamp see step 1.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.
Important!
Before starting maintenance switch off the power.