Samsung NK86NOV9MSR Manual De Utilización página 26

With any speed engaged (excluding Booster speed), by acti-
vating sensor B, the Timer function is activated.
- The LED relating to sensor B stays on followed by a sound
signal, this means that the function is active.
- After 15 minutes, at the end of the count, the hood switches
off (motor and any lights switched on).
- If one wishes to deactivate the function before the 15 min-
utes are up, activate sensors A or B.
- Clean Air
This function starts the motor for 10 minutes every hour at the
first speed for proper air recirculation in the room.
- It is activated by putting your hand in front of sensor B, the
corresponding LED switches on followed by a sound signal,
this means that the function is active.
- the motor switches on for 10 minutes every hour at first
speed during which the LED relating to sensor B and C stays
fixed on.
In the remaining 50 minutes, with the motor not running, all
LEDs are switched off.
- If one wishes to deactivate the function activate sensors
A or B.
Attention: with the "clean air" function all functions are deac-
tivated except for the LIGHTS and OFF sensor.
Sensor C = FIRST SPEED.
The motor starts at the first speed and is activated by putting
your hand in front of sensor C.
- The function is active with low extraction when the LED relat-
ing to the sensor switches on followed by a sound signal.
Sensor D = SECOND SPEED.
The motor starts at the second speed and is activated by
putting your hand in front of sensor D.
- The function is active with middle extraction when the
LED
relating to the sensor switches on followed by a sound
signal.
Sensor E = THIRD SPEED.
The motor starts at the third speed and is activated by putting
your hand in front of sensor E.
- The function is active with high extraction when the LED re-
lating to the sensor switches on followed by a sound signal.
Sensor F = BOOSTER SPEED.
With the motor running at any set speed, by activating
sensor F one engages the BOOSTER speed (4th speed) for
10 minutes
- The function is active when the LED relating to the sensor
switches on followed by a sound signal.
- With the function active the LED stays fixed on while the LED
of the previously set speed switches off.
- After 10 minutes the hood sets itself at the third speed.
- If one wishes to deactivate the function before the 10 min-
utes are up, use sensors A or F.
The BOOSTER speed can be activated even with the hood
switched off.
Sensor G = Switches the LIGHT on and off and indicates
FILTER SATURATION.
- Lights
To switch the lights on, put your hand in front of sensor G..
- Anti-grease/active carbon filters saturation:
After 30 hours of operation the LED relating to sensor G starts
to flash with a frequency of 2 seconds, this means that one
must wash the anti-grease filters.
After 120 hours of operation the LED relating to sensor G
starts to flash with a frequency of 1 second, this means that
one must wash or replace the active carbon filters.
Once the clean filter has been put back in place you must reset
the electronic memory by putting your hand in front of sensor
G and the 30h/120h setting restarts from zero.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY
FOR EVENTUAL DAMAGES CAUSED BY BREACHING THE
ABOVE WARNINGS.
- 26 -