Battery Installation; Power Off - San Jamar M Serie Hoja De Instrucciones

Thank you for purchasing a San Jamar digital scale. Please read the
following operation information to ensure the proper function of your new scale.

BATTERY INSTALLATION

1. Turn the entire scale upside down, and set it securely on a firm, flat surface.
2. Open the battery door by loosening the battery door screw.
3. Install four UM2 size C batteries in the battery compartment, ensuring that
the positive/negative side is in the direction as shown in the cabinet.
4. Close the battery door and fasten it with the screw.
AC/DC ADAPTER (OPTIONAL)
1. Open the adapter cabinet door.
2. Plug the adapter jack into the socket.
3. Take out the adapter, and close the cabinet door.
4. Plug the adapter to the AC main.
LEVEL THE SCALE
When the scale is put to use at a new location, adjust the level of the scale by
turning the 4 level adjusting feet until the bubble is located in the middle position of
the bubble leveler.

POWER OFF

1. The scale can be powered off manually by pressing the ON/OFF key.
2. For a total shut down; use the power switch on the side.
ACTIVATING THE SCALE
1. Turn on the "power on/off switch"
2. Turn the scale on by pressing ON/OFF key.
3. The LCD screen will show all characters for a few seconds, and then "0.000 "
will be shown on the display.
4. The scale turns off automatically after being idle for two minutes.
BACK LIGHT
1. You can turn the BACK LIGHT on or off by pressing the BACK LIGHT
key.
2