San Jamar M Serie Hoja De Instrucciones página 5

USING THE COUNTING MODE: SET SAMPLE SIZE
1. Turn on the scale.
2. Press and hold the PCS key for about 3 seconds until a flashing number is
displayed.
3. Press the MODE key to select the sample size in the sequence of 10 → 20 →
40 → 60 → 80 → 100
4. Once you have determined your desired sample size; place the samples on the
platform. (Example: For a sample size of 10, place quantity of 10 onto the plat-
form, for sample size of 20, place quantity of 20, etc.)
5. Press the PCS key to confirm the sample size. You can now add, and subtract
samples.
6. Press the PCS key again to return to weighing mode.
Remark: By pressing the TARE key; this will activate the accumulation of counting.
See Tare Mode Steps
In order to ensure accurate counting figure, the minimum unit sample weight must
be > ld, and the counting size must not exceed 65535 pcs. If over 65535 pcs, the
LCD will display "- - - -"
PROPER USE & CARE
• Use and stow the scale at room temperature.
• This scale is an instrument of precision. Do not submit the scale to shaking,
excessive vibration, or other rough treatment; use on a flat, and stable surface.
• The display may be affected by electromagnetic disturbances such as radios,
microwaves, or cell phones. If such disturbances occur, remove the source of
the disturbance, and restart the scale.
• Disassembling, or tampering with the scale voids the warranty.
• Clean the scale with a damp cloth; do not submerge in liquid; scale is not
waterproof.
• For best results, use alkaline batteries.
• Failure to insert batteries in the correct polarity, as indicated in the battery
compartment, may shorten the life of the batteries or cause batteries to leak.
• Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel
Cadmium) or (Nickel Metal Hydride) batteries. Do not mix old and new
batteries.
• Batteries should be recycled or disposed of as per state and local guidelines.
Do not dispose of batteries in fire!
5