Publicidad
Starting the device
To start the device, press the "ON/OFF" (
) button on the control panel of the
device.
The display now shows the temperature of the heating / cooling element meas-
ured currently. The device now starts the heat-up or cool-down phase depending
on the target temperature. The last configured value is taken as the target
temperature.
Setting the target temperature
Press the temperature selection button (
) with the device switched on. The
display now changes from the currently measured temperature (actual temper-
ature) to the target temperature (set temperature), and is shown flashing. Now
select your target temperature by increasing the value using the
"Up"(
) button or decreasing the value using the "Down"(
) button.
The selected value can be between -10 °C and + 65 °C.
This can be done as long as the value flashes on the display. If a button is not
pressed, the display stops flashing after 5 seconds, and the last configured value
is taken. Alternatively, you can also press the temperature selection button (
)
to confirm the value immediately.
Status LEDs Red (heating mode) / Green (cooling mode)
The LEDs above the display show you whether the device is in heating mode (red
LED glowing), in the cooling mode (green LED glowing), or when both LEDs are
off, if the device is currently in the target temperature range.
6. Cleaning and Care
Disconnect the plug and allow the device to cool down completely before clean-
ing. The device should not be treated with liquids or even immersed in liquids for
electrical safety reasons.
25
English
Publicidad
