Installation Instructions; Swivel Base; Power Cord - Philips 105S63 Instrucciones De Operación

INSTALLATION INSTRUCTIONS

Swivel Base

To attach the swivel base to the monitor, do the following:
• Carefully turn the monitor on its side or upside down. ( see figure 1 )
• Locate the cavities at the bottom front of the monitor.
• Insert the pegs on the swivel base into these cavities. Push the swivel base
forward until the swivel base locks in place.
• To remove the swivel base, hold the bottom of the swivel base, then push
it out.
Figure 1

Power Cord

Power Source:
1. Make sure the power cord is the correct type that required in your area.
2. This monitor has a universal power supply that allows operation in either
100/120V AC or 220/240V AC voltage area ( No user adjustment is
required. )
3. Connect the power cord into your monitor's power input socket, and then
plug the other end into a 3-pin AC power outlet. The power cord may
be connected to either a wall power outlet or the power outlet socket on
your PC, depending on the type of power cord supplied with your
monitor.
Philips_manual_
Tuesday, November 18, 2003 3:00:45 PM
Install
2
Installing and Removing the Swivel Base
3
Remove
1