Video Cable - Philips 105S63 Instrucciones De Operación

Video cable

Connecting the Video Cable: The monitor comes with a built-in video cable.
Plug the signal cable's 15-pin connector into the computer's video port and
tighten the two screws on the cable connector.
Caution:Don't bend the signal cable, otherwise it will break the inner wire.
Connecting the Power Cord: Plug the power cord into the monitor's AC
power socket. Then plug the power cord into a grounded AC outlet or UL-
approved power strip or the power output socket on your PC.
Caution: If the AC outlet is not grounded (with three holes), install the
proper grounding adapter (not supplied).
1. Power Cord
Philips_manual_
Tuesday, November 18, 2003 3:00:46 PM
1
Figure 2 Connecting Cables
2.
4
2
Signal Cable