Carson 50 060 6033 Instrucciones De Uso

Charger unit art. no. 50 060 6033
For charging transmitter, receiver and glow plug
batteries
LED1 Glow plug battery 1,5V
LED2 Receiver batteries 4x1,2V 4,8V
LED3 Transmitter batteries 8x1,2V 9,6V
1,5V = 300mA
4,8V = 200mA
9,6V = 200mA
Safety instructions
Please read the operating instructions before using the
unit for the first time.
Only use the unit in enclosed spaces.
Only for NiMH batteries.
Never attempt to recharge dry batteries.
Ensure that the battery's capacity matches the charging
current of the unit.
Keep small children away from the unit while charging.
Children should only operate the charger unit if
supervised by an adult.
Allow heated batteries to cool prior to charging.
If a battery becomes very hot (>40°C, battery poss.
defective), disconnect the power plug.
Never use the charger as a direct current supplier for
electrical appliances.
Rechargeable battery types
Transmitter battery/ies 9,6Volt
Receiver battery/ies 4,8Volt
Glow plug battery 1,5Volt
Charging process
Insert the power plug of the charger into a standard
domestic socket outlet. Connect the plug for charging the
receiver pack (4 cells) to the charger plug, pay attention
to the connector force, do not apply power. Red cable
plus / black cable minus. The charger plug for the glow
plug battery (1 cell) is connected to this similar to a glow
plug. Never connect to a starter system, which obtains
the glow plug voltage by means of reduction through a
battery with a higher voltage!
Specifications
Input voltage
Output voltage 1
Output voltage 2
Output voltage 3
Output current 1
Output current 2
Output current 3
(1,2Vx8 cells, NiMH)
(1,2Vx4 cells, NiMH)
(1,2Vx1 cell, NiMH)
AC voltage 230V 50Hz 11 W (max)
12V DC without load
6V DC without load
1,5V DC without load
200 mA
200 mA
300 mA
The charging of the three battery types can occur either
individually or simultaneously. The charging time can be
calculated as follows:
Charging time (hours) = 1.4* -----------------------------
During the charging process, the charger unit and
batteries will heat up slightly (towards the end of the
charging period).
• When charging a battery, the relevant LED will light up.
• Remove the battery from the charger at the end of the
charging period (disconnect plug).
• In the event of a defect (heat build-up) disconnect the
power plug and remove the batteries from the charger
unit.
Disposal
Please note and understand the symbols on this product,
packaging or instructions. Electronic components are
valuable materials and at the end of their useful
life should not be disposed with household
waste! Help us to protect the environment and
safeguard our resources by discarding this
equipment at a dedicated recycling point. The
authority responsible for waste disposal or
your retailer will be able to answer any
questions you may have in this respect.
Dickie-Tamiya GmbH & Co KG
Power plug
Polarity of charging jack
Charging jack
for transmitter
Charging jack for
receiver battery/ies
Charging jack for glow plug battery
battery capacity mAh
charging current mA
Service-Hotline:
(8.00 Uhr -17.00 Uhr)
(01805) 73 33 00
14 ct/min
Mittlere Motsch Str. 9
96515 Sonneberg