Service; Appliance-Specific Safety Instructions; Original Accessories/Auxiliary Equipment - Parkside PPS 200 C2 Traducción Del Manual De Instrucciones Original

5 . Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained .
Appliance­specific safety instructions
To avoid the risk of injury or fire as well as
health risks
■
When working outdoors, connect the appli-
ance via a fault current circuit breaker with
a maximum tripping current of 30 mA.
■ Use only an extension cable approved for
outdoor use.
■ Secure the workpiece! Use clamps/vice to
hold the workpiece firmly in place. This is
much safer than simply holding it in your hand .
■ In case of danger, remove the plug from the
socket immediately.
■ Always route the power cable towards the
rear, away from the appliance.
RISK OF FIRE DUE TO FLYING SPARKS!
■
Sanding metal generates sparks . Ensure that
nobody can be put at risk and that no combus-
tible materials are located in the immediate
vicinity of where you are working .
WARNING! TOXIC DUST!
► Dusts from materials such as leaded paint,
some types of wood and metal can be
harmful to your health .
Contact with or inhalation of these dusts can
represent a health hazard for the person
operating the appliance and other people in
the vicinity .
WARNING! RISKS DUE TO DUST!
► When working for extended periods of time
on wood and, in particular, materials that
produce dust which is hazardous to health,
connect the appliance to an appropriate
external dust extraction appliance . Wear
safety goggles and a protective dust mask!
PPS 200 C2
■ Provide sufficient ventilation when working on
plastics, paints, lacquers, etc.
■ Do not soak the materials or the area to be
processed with liquids containing solvents.
■ Avoid sanding lead paint or other harmful
materials.
■ Materials containing asbestos must not be
processed.Asbestos is a known carcinogen .
■ The device is designed for the dry surface
sanding of wood, plastic, metal and plaster
and painted surfaces.
■ Never work on moistened materials or damp
surfaces. Water entering a power tool will
increase the risk of electric shock .
■ Always hold the appliance firmly with two
hands while working.
■
Do not rest your hands next to or in front of
the appliance and the area being worked as
there is a risk of injury if you slip.
■ Always switch the appliance off and allow
the sanding sheet 7 to stop oscillating before
putting the appliance down.
■ Always remove the plug from the power
socket during work breaks, when adjusting
the appliance (e.g. changing the sanding
sheet) and when it is no longer in use.
■ The appliance must always be kept clean, dry
and free from oil or grease.
Original accessories/auxiliary
equipment
■ Use only the additional equipment and acces-
sories specified in the operating instructions.
Using attachments or accessory tools other than
those recommended in the operating instruc-
tions can lead to a risk of injury .
GB │ MT │ 37 ■