geberit 180.100.10.1 Manual De Instalación página 12

9
Check if the <Air purifier> and <Dryer> buttons are
pressed on the control panel. If not, press both
buttons. Air purifier starts.
10
Press the <Shower> button. The shower arm
extends and the spray starts. Increase or lower the
spray intensity by pressing the slider forwards <+>
or backwards <->.
11
Press the <Shower> button again. The dryer arm
retracts. The shower arm extends and the dryer
starts.
12
Remove your hand from the window of the user
detection. The dryer stops.
The remote control must be closer than 1 m to the
toilet so that the remote control detects the toilet.
12
13
Slide the cover of the remote control up until the
end position. Then remove the slider by pressing
the catch and insert the supplied batteries (3 x size
AAA/type 1.5 V) into the remote control.
14
Remove the spray shield and store for later use.
Result
Functions successfully tested.
Toilet is ready for use.
Acceptance
Handing over the toilet to the customer, ready for
operation
1
Explain the main functions of the toilet to the
customer.
Refer to the operating instructions for detailed
information.
2
Hand over end-user documentation to the
customer.
3
Fill in the warranty card together with the customer
(end-user documentation), attach the serial number
sticker and send it to Geberit.
4
Attach a second serial number sticker, for example
to the last page of the operating instructions, so it is
available for later use.
2
1
≤ 1 m