Cequent 45510 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Short bed truck only
1.50 (38mm)
Trim and drill heat shield
Existing 14mm
bumper bolts
r
p
o
Install attachment bars
One side at a time, remove
side M14 bolts at the outside
end of the frame rail.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 45510, 45710, CQT45510
Do Not sandwich heat shield between frame rail and hitch.
3/8" (.375)
(10mm)
Cable tie
1.50 (38mm)
Attach heat shield with cable tie as shown
Forward holes
l
m
p q
k
n
Existing 14mm
bumper bolts
p
o
Attachment
bar LH
k
j
Note: Fasteners typical both sides
Plastic heat
shield shown
install
Drilled holes both sides
Short bed only
Bumper
attachment
weldnuts
Frame attachment
14mm
weldnuts
p q
k
j
k
Bumper attachment,
j
k
14mm weldnuts
j
Bumper , exhaust & heat shield not shown
Sheet 3 of 12
Fastener Kit: 45510F
① Qty. (4) Bolt (coarse thread)
M14x2.0x45 CL10.9
② Qty. (6) Conical washer 5/8''
③ Qty. (2) Bolt (fine thread)
M14x1.5x45 CL10.9
④ Qty. (2) Spacer .250x1.5x2
⑤ Qty. (2) Flange nut
M14x1.5 CL10
⑥ Qty. (2) Bolt ½-13x1.5, GR5
⑦ Qty. (4) Conical washer 1/2''
⑧ Qty. (2) Nut ½''-13
Existing 14mm
bumper bolts.
Vehicle
Frame
Bumper
p o
Spring shackle
Conical washer
teeth side
against hitch
45510N 05-25-16
Bumper
Fascia
Rev. A