Tabla de contenido
Publicidad
Step 7
Separate the EXTENSION SLIDES (U) from the EXTENSION RAILS (T)
å
as shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (T) to the ENDS (A and B). Use four
å
GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge of the
EXTENSION RAIL in to fi nd the other hole that lines up with the hole in
the END. Turn a SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWER.
å
Open end
T
www.sauder.com/services
U
Push the black lever in and pull the SLIDE from the RAIL.
B
P
Open end
T
A
419960
T
H
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Page 11
Publicidad
Tabla de contenido
