Atlantic Maradja Manual De Utilización E Instalación página 13

To maintain performances of your unit, you should clean the entries and exits of air about twice a year using a vacuum
cleaner or a brush. Have a professional check the inside of the unit every five years. The unit casing should be
cleaned with a damp cloth, never use abrasive products.
The unit does not heat :
Check that the programmer is in COMFORT mode.
Make sure that the installation circuit breakers are switched on, or that the load shedder (if you have one) has not
switched off the unit power supply. Check the air temperature in the room.
The unit does not carry out programming orders :
Make sure that the programming unit is being correctly used (refer to its user's manual) or that the K7 Program
is properly inserted in its housing and that it is operating normally (batteries?).
The unit is permanently heating :
Make sure that it is not in a draft and that the temperature setting has not been changed.
This unit with electronic control is equipped with a microprocessor that can be disturbed by some severe mains voltage
disturbances (outside EC standards defining the disturbance protection level).
If there are any problems (thermostat blocked, etc.) switch off the unit power supply (fuse, circuit breaker, etc.)
for about 10 minutes to allow the unit to start again.
Have your energy distributor check your power supply if the phenomenon occurs frequently.
KEEP THIS DOCUMENT IN A SAFE PLACE
(This certificate should only be produced if you are making a complaint, attached with the invoice of the purchase)
- This guarantee is applicable for 2 years from the date of original purchase and shall be valid for no more than 30 months
from the date of manufacture.
- Your Atlantic distributor will exchange parts shown to be defective in manufacture. The replacement parts will be free of
charge but Atlantic does not accept responsability for freight or labor charges or losses in transit.
- This guaranteeexcludes damage by neglect, shipping or accident and any damage due to incorrect installation, use for
purposes other than those intended or failure to observe the instructions given.
UNIT TYPE*
SERIAL NUMBER*
CUSTOMER'S NAME AND ADRESS
* This information is shown on the plate which can be seen on the left-side or behind the front grille of the unit.
ATLANTIC Internati
Tél : (33) 146836000 / (33)2 38713846
Fax : tél : (33) 1 46 836001
MAINTENANCE
TROUBLE-SHOOTING
WARRANTY CONDITIONS :
onal
INSTALLER'S STAMP