Wet/Dry Vac Assembly; Installing Tool Holder; Insert Hose - RIDGID WD18510 Manual Del Usuario

SP6733-3 Ridgid WD1851 ES
Drum/Caddy Assembly (continued)

Installing Tool Holder

Install tool holder as shown with
extension wand holders facing unit.

Wet/Dry Vac Assembly

1. Position the powerhead assembly on
the drum/caddy assembly as shown
(assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.

Insert Hose

Insert the push button end of the "Dual-
Flex™ Locking" hose into the inlet of the
Vac. The hose should snap into place.
To remove the hose from the Vac, press
the release button in the hose assembly
and pull the hose out of the Vac inlet,
as shown.
Press Release
and Button
Pull
11/29/12 3:42 PM Page 9
Drum
Latch
9
Tote Snaps
Tote
Straps (4)
Handle
Drum
Latch
Drum
Flange
Powerhead
Assembly
Latch
Drum