Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Q1:
After connecting the TEG-S811Fi to a power outlet, the LEDs do not turn on.
A1:
Check the connection of the power cord to the TEG-S811Fi and the power outlet. Also
check that the power outlet is receiving power.
Q2: How do I configure TCP/IP settings on my computer?
1. Go into the Control Panel and double-clic the Network
Connections icon, right-click the Local Area
Connection icon and then click Properties.
Q3:
I connect the switch to my network via the mini-GBIC module, but I am unable to make a
connection.
A3:
First, verify that you are using the proper fiber cable. Second, verify that the TX and RX
cables have been reverse on the opposite Fiber connection. Third, when connecting to the
mini-GBIC modules, your Fiber connection must be Gigabit. Fourth, power down the switch.
Wait 15 seconds, then plug the switch back in.
Q4:
How do I login to the switch via the console port?
A4:
Follow the instructions below:
1) Connect the RS-232 cable from a serial port on your Windows PC to the console port on
your computer.
2) Go to Start -> Programs -> Accessories -> Communications -> Hyperterminal
3) Enter a name, select an icon and then click OK.
4) Select the correct COM port (e.g. COM1, COM2) and then click OK.
5) Enter the following, click Apply and then click OK:
Bits per second: 9600
Data bits:
Parity:
Stop bits:
Flow control: None
6) Press Enter.
7) Enter the user name and password. By default, the user name and password is root.
Please refer to the User's Guide for a list of commands.
If you still encounter problems or have any questions regarding the TEG-S811Fi, please contact
TRENDnet's Technical Support Department.
2. Click Internet Protocol (TCP/IP) and then click
Properties. Then click on Use the following IP
address, and make sure you assign your network
adapter an IP address in the subnet of 192.168.16.x.
8
None
1
5
Publicidad
