Descargar Imprimir esta página

Halls Greenhouses Halls Universal 128 SD Manual Del Usuario página 4

Publicidad

May we congratulate you on your new greenhouse
GB
Dear Customer!
Dear Customer!
The assembly of your new greenhouse
requires no technical knowledge. However, it
The assembly of your new house requires
is important that the assembly instructions are
a bit of technical knowledge. However, it is
strictly followed. The assembly instruction
important that the assembly instructions are
is a combination of text and illustrations. The
followed strict-ly. The assembly instruction
profiles are packed seperatly in numbered
is a combination of text and illustrations. The
packs corresponding to the order in the
profiles are packed in separate numbered packs
assembly instruction. Erect one pack at a time.
corresponding to the order in the assembly
All nuts and bolts and fittings are found in bag
instruction. Erect one pack at a time. All nuts
No. 0. Each pack is specified i separate lists of
and bolts and fittings are found in bag No. 0
components.
(specified on page 12). Each pack is specified in
All detailed illustrations are marked with
separate lists of components.
symbols:
All detailed illustrations are marked with
symbols:
Seen from
Seen from the outside
Seen from inside
Seen from outside.
the inside
Precautions.
Precautions.
Assembly must only be carried out in dry
Assembly must only be carried out in dry
and calm weather.
and calm weather.
Always use working gloves while glazing.
Always use working gloves while
Greenhouse glass has sharp edges,
glazing Greenhouse glass has sharp
especially if the glass breaks.
edges,especially if the glass breaks.
Assistants and especially children must be
Assistants and especially children must be
warned that broken glass is an element of
warned that broken glass an element of
danger. Pick up broken glass at once and
danger. Pick up broken glass at once and
remove it with care.
remove it with care.
We recommend to use protective glasses
We recommend to use protective glasses
while fixing the spring wire clips.
while fixing the spring wire clips
Place the ladder on a level support.
Place the ladder on a level support.
It is essential to have an assistant.
It is essential to have an assistant.
References
Foundation
The column marked
indicates the
The base is not included in this delivery.
page(s) on which the component is used.
However, an optional base can be bought
separately. It ensures you have a stable and
Page 13:
easy to build base. If you make your own base
Foundation
the measurements indicated must be external
The base is not included in this delivery.
measurements.
However, an original base can be bought
If you buy an optional base you furthermore
separately. It ensures you a stable and easy to
need about 75 litres of concrete and 6 plastic-/
build base.
concrete pipes of about 800 mm which
If you make your own base the measurements
are placed in a non-freezing depth for the
indicated must be external measurements.
fastening of the corner and middle anchors.
If you buy an original base you furthermore
The base must be 100% level and square; the
need about 75 litres of concrete and 6/8
latter is ensured by checking that the two
plastic-/concrete pipes of about 800 mm which
diagonal measurements are equal.
are placed in a non-freezing depth for the
fastening of the corner and middle anchors.
Attachment to the base
The base must be 100% level and square; the
Using an optional base the greenhouse is
latter is ensured by checking that the two
fastened to each vertical bar as shown on
diagonal measurements are equal.
drawing A.
Tools
Order of assembly
The mounting of the greenhouse requires the
Place the components as shown on the
tools shown on page 12.
illustration and assemble in the order shown
in the pictures. Do not tighten the nuts
Page 14-27:
completely until the front gable construction
Place the components as shown on the
has been assembled.
illustration and assemble in the order shown
in the pictures. Do not tighten the nuts
completely until the front gable construction
has been assembled.
Fitting of glass/polycarbonate
Page 13:
Important before glazing!
(Fastening to the base).
Make sure that gables and sides are level and
When constructing your own base you have
square, and that door(s) and window(s) are
to drill holes (7 mm) in the ground frame
functioning perfectly.
between all the vertical frames, the greenhouse
is then fastened to the base with screws (A).
Best order of assembly:
Using an original base the greenhouse is
1) Rear gable – 2) Front gable – 3) Sides –
fastened to each vertical bar as shown on
4) Frame assembly – 5) Roof and bracing 6)
drawing B/C.
Doors – 7) Vents – 8) Glazing
Page 24-27:
Glass installation
For an easier assembly we recommend that you
Degrease the sheets and frames with spirit.
oil the screws for the doors.
Start glazing from below, one glass at a time.
Fit glazing strip (411) to all glazing bars, gable
Fitting of glass/polycarbonate
bars and corner posts before you begin to
Important before glazing!
glaze the greenhouse.
Spring wire clips and glassholders are to be
Make sure that gables and sides are level and
fitted as shown.
square, and that door(s) and window(s) are
functioning perfectly.
X = Spring wire clips, > = Glassholders
Best order of assembly:
Polycarbonate installation
1) Windows – 2) Roof – 3) Doors – 4) Gables
The type indication states the length in mm.
– 5) Sides
A possible adjustment is made by means of a
fine tooth saw.
Page 30-33:
NB! To avoid the formation of algae the
Glazing (illustration 1 to 8)
polycarbonate sheets must not come into
Degrease the sheets and frames with spirit.
contact with the ground. Rest them on a piece
Start glazing from below, one glass at a time.
of cardboard.
Apply a 3 mm silicone line on the vertical
frames where indicated (dotted lines on
Sealing of the polycarbonate sheets
the illustration). (A 3 mm line of silicone is
The sheets may be sealed against insects.
sufficient to obtain maximum attachment). If
Close the top end off with alu-tape or silicone.
you do use more than recommended, you can
The bottom only with airstrip tape to let
buy extra tubes.
condensation out
(available at your local dealer).
Spring wire clips and glassholders are to be
fitted as shown.
WATER AND CONDENSATION
X = Spring wire clips, > = Glassholders
Please note that your greenhouse is not like a
conservatory, for example, and that you should
In case of broken glass carefully pull it
therefore be aware that the greenhouse may
outwards and loosen the silicone by means of a
leak during or after precipitation and that
sharp craft knife.
condensation will occur on the inside of the
Clean the profile completely before inserting a
greenhouse. Good ventilation will help prevent
new pane of glass.
condensation.
Page 34-37:
Mounting of polycarbonate
Now your greenhouse is completely
The illustrations at the bottom of page 34/36
assembled. However, please notice the
show where to mount the polycarbonate plates
following:
and lists. The type indication states the length
in mm. A possible adjustment is made by
Maintenance
means of a fine-tooth saw.
Grease doors (hinges and lock or
NB! To avoid the formation of algae the
doortrack).
polycarbonate sheets must not come into
contact with the ground. Rest them on a piece
Clean the gutter for leaves, etc.
Adjustment of windows.
of cardboard.
Replacement of broken glass.
A-lists are mounted as shown on page 35/37.
Clean the greenhouse with disinfectant
before and after the growing season.
Put the sheet into the bottom list, bend the
sheet slightly outwards and put it in the top list.
M-lists are mounted as shown on page 35/37.
Place the upper part of the list under the alu.
profile in the whole length of the sheet and
www.hallsgreenhouses.com
hereafter click on the list from above.
Please refer to website for the most up to date instructions.
WATER AND CONDENSATION
Sealing of the polycarbonate sheets
Please note that your greenhouse is not like a
The sheets may be sealed against insects.
conservatory, for example, and that you should
Close the top end off with alu-tape or silicone.
therefore be aware that the greenhouse may
The bottom only with airstrip tape to let
leak during or after precipitation and that
condensation out (available at your local
condensation will occur on the inside of the
dealer).
greenhouse. Good ventilation will help prevent
condensation.
Now your greenhouse is completely assembled.
However, please notice the following:
Winter Protection
In areas with occurrence of snow we
Maintenance
recommend the following winter protection:
Winter Protection
In areas with occurrence of snow we
recommend the following winter protection:
Insurance
Please note that not all insurance companies
cover greenhouses automatically. Please
contact your insurance company to ensure an
insurance coverage.
Guarantee
Juliana grants a guarantee of 12 years which
covers replacement of faulty parts. The
Insurance
guarantee does not cover polycarbonate,
Please note that not all insurance companies
glass, transport, assembly, freight etc.
cover glasshouses automatically. Please
Juliana grants a guarantee of 2 years on
contact your insurance company to ensure an
painted parts, if any. Note that marks in the
insurance coverage.
painting may occur due to suspension of the
profiles.
Guarantee
The guarantee is invalid if the greenhouse is
Juliana grants a guarantee of 12 years which
not assembled according to these instructions.
covers replacement of faulty parts. The
guarantee does not cover polycarbonate, glass,
Complaints
transport, assembly, freight etc.
All our greenhouses are built to high standards
Juliana grants a guarantee of 2 years on painted
of quality. However, should a complaint
parts, if any. Note that marks in the painting
occur please contact your dealer at once.
may occur due to suspension of the profiles.
Remember to specify the defect by indicating
The guarantee is invalid if the greenhouse is
the greenhouse model and number of the
not assembled according to these instructions.
component.
Complaints
Congratulations on your new greenhouse,
All our greenhouses are built to high standards
which we hope will bring you a lot of pleasure
of quality. However, should a complaint
for many years to come.
occur please contact your dealer at once.
Remember to specify the defect by indicating
the greenhouse model and number of the
component and the quality control number.
B
USA
Grease doors (hinges and lock).
Support the roof ridge at the centre of
Clean the gutter for leaves, etc.
the greenhouse.
Adjustment of windows.
Remove greater snow loads from the
Replacement of broken glass.
roof.
Clean the house with disinfectant before
Take precautions against snow falling
and after the growing season.
down from for instance a tree or a roof.
Dismount the cylinders for the automatic
window openers, if any (optional extras).
Secure door(s) and window(s) preventing
wind damage to the greenhouse.
Support the roof ridge at the centre of the
house.
Remove greater snow loads from the roof.
Take precautions against snow falling
down from for instance a tree or a roof.
Dismount the cylinders for the automatic
window openers, if any (optional extras).
Secure door(s) and window(s) preventing
wind damage to the house.

Publicidad

loading

Este manual también es adecuado para:

Halls universal 128 dd128 sd128 ddUniversal 128 sdUniversal 128 dd