Uline H-7174 Guia De Inicio Rapido

H-7174
BULK SOAP AND SANITIZER
AUTO WALL-MOUNT
DISPENSER – 34 OZ.
TOOLS NEEDED
Phillips Screwdriver
OPENING DISPENSER
1. To open, insert key on the bottom of dispenser,
push key upward into the dispenser. (See Figure 1)
2. The front will open towards user.
Figure 1
GENERAL MOUNTING INSTRUCTIONS
• Can use double sided tape (not included) on
glazed tile, painted or unpainted metal walls. Tape
will not work well if wall surface is porous, like brick or
wood.
• On all other wall surfaces, use screws and anchors
(included) or other appropriate hardware based on
surface type.
• Install dispenser at least 8" above a sink or counter.
Never install where it can drip on floor, creating
hazardous conditions.
PAGE 1 OF 9
1-800-295-5510
uline.com
Electric Drill
INSTALLATION
• If dispenser is mounted too close to the sink or
counter or if it senses an obstacle in its way, the
LED light will blink green frequently. If it is able to
make internal adjustments, after 15 seconds the
LED light will go back to normal. If it is not able to
make the appropriate adjustments, the LED light
will blink green and red until obstacle is removed
or dispenser is remounted at correct distance from
counter or sink.
• To be in compliance with ADA regulations, the
dispenser should be mounted no more than 48"
from the ground.
NOTE: Dispenser opens towards the front. For
ideal placement, the dispenser should be
mounted 8" above any countertop, fixture or
obstruction and 2" below any cabinet, fixture or
obstruction.
MOUNTING WITH DOUBLE-SIDED TAPE
1. Thoroughly clean wall surface using a general
purpose cleaner and a paper towel. Let dry
completely. For silicone buildup, use a pumice-type
cleaner or grout cleaner to clean the surface.
(See Figure 2)
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
Figure 2
0121 IH-7174