Installing A Prewound Reel - Bolens BL50 Manual De Instrucciones

MAINTENANCE & REPAIR INSTRUCTIONS
Single Line Installation
Go To Step 8 for SplitLine™ Installation
6. Cut approximately 25 feet (7.6 m) of new trimming line,
then loop it into two equal lengths. Insert each end of the
line through one of the two holes in the inner reel
(Fig. 14). Pull the line through the inner reel so that the
loop is as small as possible.
7. Wind the lines in tight even layers, onto the reel
(Fig. 15). Wind the line in the direction indicated on the
inner reel. Place your index finger between the two lines
to stop the lines from overlapping. Do not overlap the
ends of the line. Proceed to step 11.
SplitLine™ Installation
8. Cut approximately 12 feet (3.65 m) of new trimming line.
Insert one end of the line through one of the two holes in
the inner reel (Fig. 16). Pull the line through the inner reel
until only about 4 inches is left out.
9. Insert the end of the line into the open hole in the inner
reel and pull the line tight to make the loop as small as
possible (Fig. 16).
10. Before winding, split the line back about 6 inches.
11. Wind the line in tight even layers in the direction
indicated on the inner reel.
NOTE: Failure to wind the line in the direction indicated will
cause the cutting attachment to operate incorrectly.
12. Insert the ends of the line into the two holding slots (Fig. 17).
Fig. 15
13. Insert the ends of the line through the eyelets in the
outer spool and place inner reel with spring inside the
outer spool (Fig. 18). Push the inner reel and outer spool
together. While holding the inner reel and outer spool,
grasp the ends and pull firmly to release the line from the
holding slots in the reel.
NOTE: The spring must be assembled on the inner reel
before reassembling the cutting attachment.
14. Hold the inner reel in place and install the bump knob by
turning clockwise. Tighten securely.

INSTALLING A PREWOUND REEL

1. Hold the outer spool with one hand and unscrew the
bump knob counterclockwise (Fig. 10). Inspect the bolt
Fig. 16
inside the bump knob to make sure it moves freely.
Replace the bump knob if damaged.
2. Remove the old inner reel from the outer spool (Fig. 11).
3. Remove the spring from the old inner reel (Fig. 11).
4. Place the spring in the new inner reel.
NOTE: The spring must be assembled on the inner reel
before reassembling the cutting attachment.
Loop 5. Insert the ends of the line through the eyelets in the
outer spool (Fig. 18).
6. Place the new inner reel inside the outer spool. Push the
inner reel and outer spool together. While holding the inner
reel and outer spool, grasp the ends and pull firmly to
release the line from the holding slots in the reel.
7. Hold the inner reel in place and install the bump knob by
turning clockwise. Tighten securely.
Replacement Parts
Refer to the Accessories / Replacement Parts section.
11
Eyelet
Fig. 17
Holding Slots
Fig. 18
Eyelet
Spring