Prepare For Installation - GE IM-4D Manual Del Propietário

ICEMAKER INSTALLATION INSTRUCTIONS
REMOVE THE OUTLET COVER
3
Peel off the outlet cover.
INSTALL FILL TUBE
4
Go to the back of the refrigerator. On the refrigerator
side of the fill tube assembly (11 or 12 depending
on model), there is an adhesive backing. Remove the
adhesive backing and slide the tube into the hole near
the top at the back of the refrigerator. Firmly press on
the fill tube assembly to secure it to the refrigerator.

PREPARE FOR INSTALLATION

5
Inside the freezer, loosen the two mounting screws
(B) but do not screw them all the way out. Your model
may have screws already installed; if not, remove the
2 plug buttons and insert the 2 Phillips head screws
1/2" (13 mm) out from the freezer wall.
B
Installation Instructions
REMOVE ONLY
TO INSTALL
WATER FILL TUBE
11 12
or
10
SET POWER SWITCH TO OFF
6
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply
to prevent premature operation.
Power
Switch
(Appearance may vary)
INSTALL THE ICEMAKER FILL CUP
7
For letters U & V :
Install the icemaker fill cup (13) into the icemaker
as shown.
For letter W :
Install the icemaker fill cup that came with your
refrigerator into the icemaker as shown. If the fill cup
the icemaker, there is the possibility of water leaking
into the freezer and not into the icemaker.
PLUG IN THE ICEMAKER
8
Holding the icemaker in
place, insert the icemaker
power cord plug into the
socket on the side wall,
making sure the prongs
and holes are matched.
Press the plug firmly into the
socket. Lock the plug in place
by clipping the restraints
onto each side of the plug.
Make sure the restraints click into place. Make sure
the power cord is still in the hook on the back of the
icemaker.
(CONT.)
13
(Appearance
may vary)
Hook