HAMPTON BAY 51563 Guía De Uso Y Cuidado página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly - Standard Ceiling Mount
1
Preparing for standard mounting
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (II) located in the "L
shaped" slots.
Remove and save the two canopy screws (HH) in the round
holes. This will enable you to remove the mounting bracket
(A).
A
HH
3
Assembling the fan
WARNING: Failure to properly install the locking pin (DD)
could result in the fan becoming loose and possibly
falling.
Loosen, but do not remove, the setscrews (JJ) on the collar
on top of the fan-motor assembly (D).
Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar on top of the fan-motor
assembly (D).
Carefully insert the hanger pin (CC) through the holes in
the collar and ball/downrod assembly (B). Be careful not to
jam the hanger pin (CC) against the wiring inside the ball/
downrod assembly (B).
Insert the locking pin (DD) through the hole near the end of
the hanger pin (CC) until it snaps into its locked position.
Re-tighten the setscrews (JJ) on the collar on top of the fan-
motor assembly (D).
2
Routing the wires
Make sure the slot openings are on top and route the
wires exiting the top of the fan-motor assembly (D)
through the canopy (C) and then through the ball/down-
rod assembly (B).
II
C
CC
7
Please contact 1-855-HD-HAMPTON for further assistance.
C
B
D
C
B
DD
JJ
D
HAMPTONBAY.COM

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

51564

Tabla de contenido