Front Panel - Ltc Audio KARAOKE-STAR1MKII Manual De Instrucciones

Front panel

POWER: Press this button to power ON or OFF the unit
SD: Connect your SD card here
USB: Connect your USB flash drive here
Treble: Turn this knob to adjust the treble of main output
Bass: Turn this knob to adjust the bass of main output
Balance: Turn this knob to adjust the balance of main output.
MIC VOL: Use this knob to adjust the microphone volume
MIC Echo: Use this knob to adjust the microphone echo
MIC1 & MIC2: Connect your microphones here
Input: Press this button to switch among all the inputs.
Play/Pause: Press this button to play the signal from USB/SD, Bluetooth. Press again to pause
IR: Infrared sensor to receive the signal from the remote control
Previous: Press this button to go back to the beginning of the current track or move to the previous track or move
to previous station.
Next: Press this button to move to the next track or move to next station.
Master Volume: Use this knob to control the master volume.
Headphone: Connect your headphone here
OPERATION
Select a central location for the amplifier.
Connect the speaker wires (red & black) to the + and – terminals on the rear panel of the amplifier.
Connect the audio signal to the relevant sockets with the correct polarity.
Plug the mains lead in and switch the amplifier on once you have checked all connections.
Switch the audio sources on and adjust the master volume to the required level.
Karaoke: Plug a mic into MIC1 or MIC2 socket on the front panel. Before you use the mic, make sure that it is
switched off and the MIC volume button is set to the minimum. Connect the microphone, switch it on and adjust
slowly the volume and the echo.
If you don't use the unit any longer, switch the amplifier off and disconnect it from the mains.
Signal Sources and their Connections:
• Connect a DVD-player or a CD-player to the terminal AUDIO INPUT or a data storage unit to the USB-interface
or insert a SD-memory card in the suitable slot or activate the Bluetooth function on your smartphone.
• Select the active signal source by pressing the INPUT button until the desired input source is displayed.
• Use the MP3 CONTROL-function for controlling the files on a connected data storage unit.
• If you wish to use the karaoke function of this device, insert one or two microphones into MIC1 and MIC2. Their
signals are going to the signal output too.