Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
2. Use the Allen wrench to tighten the Allen head screw. The washer is not
required to mount the sanding plate.
3. Place the sanding sheet
Push firmly so that the Velcro backing holds in place.
Operation
Getting started
1. Make sure that the multifunction tool has been properly prepared as
described in the chapter "Preparing the multifunction tool".
2. Connect the multifunction tool to a power supply plug.
3. Switch the extractor on.
4. Use the On/Off switch
5. Use the speed control
Set the speed control to level 1 for low vibration (oscillation) and to level 6 for
intense vibration (oscillation). Make sure that you use the correct speed for
the work material or test various speeds on the work material to determine
the correct one.
6. Hold the multifunction tool up to the workpiece.
You can now process the workpiece.
Finishing work
1. Take the multifunction tool out of the workpiece.
2. Use the On/Off switch
3. Switch the extractor off.
4. Pull the power plug
Cleaning and maintenance
WARNING!
Burn hazard!
Some tools become hot during operation. You could burn
yourself.
− Always let them cool off completely before cleaning!
AFTER SALES SUPPORT
USA
1 866 326 6446
12
on the sanding plate so that they are aligned.
1
to switch the multifunction tool on.
3
to adjust the speed (see fig. F).
1
to switch the multifunction tool off.
5
.
meister-service@meister-werkzeuge.de
USA
Operation
17
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
