Descargar Imprimir esta página

Honeywell EFY-041 Serie Manual Del Usuario página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS (cont'd)
B. Base Assembly
• Align the two portions of the circular base and snap together
by gently pushing the 4 round extrusions (Fig. 7, Item A) into
the adjacent circles of the connecting piece (Fig. 7, Item B).
C. Securing the Pedestal to the Base
• Line up the arrow marked as on the pedestal with the arrow
marked as on the base (Fig. 8). Align the 3 round extrusions
with the 3 holes in the base.
• Secure the base assembly to the pedestal by inserting and
tightening the 3 thumb screws in the 3 holes located on the
bottom of the base (Fig. 9).
D. Securing the Tower Fan to the Pedestal
• Carefully turn the fan on its side. Place the power cord
through the center of the pedestal and base assembly.
• Align the pedestal arrow marked as with the tower fan
arrow marked as . Firmly hold the base steady and
rotate the pedestal assembly clockwise to lock the tower
fan in place (Fig. 10).
• Secure the pedestal to the tower fan by inserting and
tightening 1 thumb screw in the opening located near the top
rear of the pedestal assembly (Fig. 11).
E. Securing the Cord to the Base
• With the fan still on its side, locate the cord holding bracket on
the bottom of the base.
• Gently pull any slack out of the power cord, place the power
cord securely in the holding bracket and secure the power
cord bracket over the power cord (Fig. 12).
• Return the tower fan to its upright position.
Note: Do not operate the tower fan unless it is in its proper,
upright position.
Note: Only one thumb screw is needed for the low height
option. Do not discard the additional screws as they will be
needed for Tall Height Option.
F. Placing the Remote Control in the Storage Area
• Locate the remote control that has been provided with the
tower fan. Make sure that the remote control is not thrown
out with the packing materials.
• Install batteries into the remote control battery compartment
(see Battery Installation/Replacement Instructions).
• Place the remote control in the recessed remote holder
located on the top of the fan (Fig. 13).
4
ASSEMBLY INSTRUCTIONS (cont'd)
BATTERY INSTALLATION/REPLACEMENT INSTRUCTIONS
Fig. 7
A. Separate the front and rear housing by inserting a small coin into the two recessed
A
slots located on the bottom of the remote (Fig 14). Twist the coin until the housings
separate. Pull the remote open, separating the halves (Fig. 15). This will automatically
B
force the lens cover to dislodge.
B. Insert 2 AAA batteries into the remote following the directional guides in the recessed
Base Assembly
slots (Fig. 16).
Fig. 8
C. S nap the remote together by lining up the front and back and firmly pressing
together.
D. R eplace the Lens Cover to its original location by snapping back into place (Fig. 17).
Fig. 14
Fig. 9
NOTE: DO NOT MIX OLD AND NEW BATTERIES. DO NOT MIX ALKALINE, STANDARD
Fig. 10
(CARBON-ZINC) OR RECHARGEABLE (NICKEL-CADMIUM) BATTERIES.
Fig. 11
Fig. 12
Fig. 13
Fig. 15
Coin
Fig. 16
Fig. 17
5

Publicidad

loading