Seeder Position - GASPARDO PENTA PE 300 Empleo Y Mantenimiento

ENGLISH

3.2.5 SEEDER POSITION

It is important to adjust the position of the planting unit correctly
on the supporting equipment when in the field.
Positioning the seeder on the equipment is an extremely
dangerous phase. Proceed with extreme caution and carry
out the operation scrupulously adhering to the instructions
provided.
1) Before positioning the seeder, it is important to place the
equipment in the position in which it is to operate.
2) Adjust points (A) and (B) Fig. 18 of the planting unit so that the
seeding element support bar is at a height of approx 45 to 50
cm from the ground (Fig. 20), and at the same time does not
interfere with the rear roller of the equipment
If the operating position of the equipment needs to be changed,
re-position the seeder by proceeding as described earlier in
point 2).
3) Connect and secure the seed delivery tubes to the furrow
opening parts with the ring provided (Fig. 19), and check their
length: during the work the formation of loops and folds, and
therefore breakages, should be avoided. If necessary adjust
their length as shown in Figure 20.
40
DANGER
ATTENTION
USE AND MAINTENANCE
fig. 18
fig. 19
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5
fig. 20
g
B
A
cod. 19702620
cod. 19501163