Total Erasing Of Transmitter Codes; Input Of A Code Already In Memory; Programming Of The Radio Receiver; Code Replacement - V2 ELETTRONICA PRGU433PP Manual De Instrucciones

TOTAL ERASING OF STORED TRANSMITTER CODES
(PRGU433PP - PRGU433PP127)
It is necessary to follow these directions:
• Disconnect the power supply.
• Press the receiver's PROG.RX button; at the same time supply power.
• The receiver's LED flashes: release PROG.RX
• The 83 memory zones are now empty and ready for a new programming.
IMPORTANT: A partial deletion of stored codes is not avilable.

INPUT OF A CODE ALREADY IN MEMORY

(PRGU433PP - PRGU433PP127)
If you try to memorize a code already in memory, the receiver's led starts flashing as
many times as the number of the already taken memory zone.
To distinguish this function from ordinary programming, the led flashes faster and remains
on for about 4 s during the last flashing. The user can employ this function to identify at
any time the memory zone taken by every single transmitter previously memorized inside
the system.

PROGRAMMING OF THE RADIO RECEIVER

(PRGU433RY)
To correctly store the code, a minimum distance of 1.5 meters between the transmitter
and the receiver antenna must be observed. To program the radio receiver, please
proceed as follows:
• Keep PROG.RX pressed until the led L1 lightens
• Keep the button of the transmitter pressed until the led L1 goes off.
• Once the flashing have ceased, the system is ready to be used.

CODE REPLACEMENT

(PRGU433RY)
The memorized transmitter code can be replaced by a new code by following the same
procedure used for the memorization. In this way the new code will be memorized and the
previous one cancelled.
17