emco Woodcore Serie Guia De Instalacion página 2

1 DISASSEMBLE
LOCKCASE
(Images shown are for a Left
Hand installation. A Right
Hand installation would be on
the opposite side shown.)
a
SET SCREW
G
H
TORNILLO DE AJUSTE
VIS DE BLOCAGE
B
D
G
1.
Loosen set screw on interior handle (B).
Remove handles (A and B) and nylon
washers (J).
2.
Remove screws (G) from interior trim plate
(D) to remove trim plates.
3.
Remove screws (H) from lock case face plate
(L) to remove lock case.
INSTALL LOCKCASE
2
(Left Hand)
a
LEFT HAND DOOR
PUERTA CON BISAGRA A LA DERECHA
PORTE AVEC LA POIGNÉE VERS LA
GAUCHE
E
RIGHT HAND DOOR
PUERTA CON BISAGRA A LA
LA PORTE AVEC LA POIGNÉE
VERS LA DROITE
LATCH BOLT
CERROJO MUERTO
PÊNE DORMANT
1.
Position the lock case (E) so that the latch
bolt is above the dead bolt as shown.
Determine if the latch bolt is in the correct
position for a left hand or right hand
door from the images. Note: the rounded
portion of the latch bolt needs to be facing
the latch rail. If latch bolt is in correct
position, proceed to step 2c.
7
8
Tools needed:
9
12
i
13
VIEW
14
A
J
L
H
5/8"
5/8"
Tools needed:
b
L
!
DERECHA
M
P
U
1.
5/8" Remove the face plate (L) from the lock case
by unscrewing the face plate screws (M).
2.
Rotate the latch bolt to the correct position
for a left hand or right hand door.
3.
Once latch is in correct position, reattach
face plate to lock case with face plate
screws (M).
5/8"
!
1 1/2"
1 1/2"
!
RIGHT HAND DOOR
PUERTA CON BISAGRA A LA
DERECHA
LA PORTE AVEC LA POIGNÉE
VERS LA DROITE
1/2"
2
!
1/2"
2"
c
U
1.
Insert lockcase (E) into slot in edge of door.
i
VIEW
P
E
1/2"