Publicidad
Idiomas disponibles
Idiomas disponibles
2. Next, determine if the truck is equipped with tow hooks.
For models without tow hooks:
a. Remove the hex nuts from the two lower bumper bolts, (Figure 2).
b. Select (1) Upper Frame Bracket, (will fit left or right-without tow hooks only), and the driver side
Mounting Bracket, (Figure 3). Bolt the two Brackets together with (2) 12mm Flat Washers, (2)
12mm Lock Washers and (2) 12mm Hex Nuts. Do not tighten at this time.
Driver/left
Mounting Bracket
(Fig 3) Driver side Bracket layout in "no tow hook"
position
Bumper support
(Fig 2) Driver side pictured from behind bumper (no
tow hook model with bumper support)
Upper Frame
Bracket
Page 3 of 24
I-Sheet Number 10777 Rev.B
Remove the (2) factory hex nuts
from the lower bumper bolts
Front
3-1/2" OVAL BULL BAR
09-15 DODGE RAM 1500
03/08/16
Publicidad
