One-Pieced Oors - Sears CRAFTSMAN 139.53648D Manual Del Propietário

ONE-PIECE
D OORS
Please read and comply with the warnings and
reinforcement instructions on the previous page.
They apply to one-piece doors also.
• Center the door bracket on the top of the door, in
line with the header bracket as shown. Mark either
the left and right, or the top and bottom holes.
• Drill 5/16" pilot holes and fasten the bracket with
hardware supplied.
If the door has no exposed framing, drill 3/16" pilot
holes and fasten the bracket with 5/16"x1-1/2" lag
screws (not provided) to the top of the door.
NOTE: The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement drawing.)
Drill 3/16" pilot holes and substitute 5/16"x1-1/2" lag
screws (not provided) to fasten the bracket to the
door.
HARDWARE SHOWN ACTUAL SIZE
Nut 5/16"-18 LockWasher 5/16"
Carriage Bolt
5/16"-18x2-1/2"
Header Wall
2x4 Support -- Finished Ceiling --
/
Header
Bracket
Optional
Placement
of Door
Bracket
Door
Bracket
Centefline of
Garage Door
Horizontal and vertical
reinforcement is needed for
lightweight garage doors
(fiberglass, aluminum, steel,
door with glass panel, etc.).
(Not Provided)
Door
Bracket
Carriage Bolt
5/16%18x2-1/2"
For a door with no exposed framing, _
or for the optional installation, use
6
i
5/16 'x1-1/2" lag screws (Not Provided)
to fasten door bracket.
Lock Washer
5/16"
• Top of Door
(inside
of Door
Optional
Placement
24