Parkside PTBM 500 D4 Traducción Del Manual De Instrucciones Original página 61

Service:
• Have your power tool repaired
only by qualified specialists and
only with original spare parts.
This will ensure that the power tool re-
mains safe.
Safety Instructions for Box
Column Drills
• Never make the warning labels
on the power tool illegible.
• Attach the power tool to a solid,
flat and horizontal surface. If the
power tool can slip or wobble, the bit
may not be guided smoothly and safely.
• Keep the work area clean ex-
cept for the workpiece to be
machined. Sharp-edged drilling chips
and objects can cause injury. Material
mixtures are particularly dangerous.
Light metal dust can burn or explode.
• Set the correct speed before
starting work. The speed must
be appropriate for the drill dia-
meter and the material to be
drilled. At an incorrectly set speed the
bit may get jammed in the workpiece.
• Only when the device is turned on
should the bit be moved against
the work piece. Otherwise there is a
danger that the bit will get jammed in the
workpiece and the workpiece will rota-
te with the bit. This can lead to injuries.
• Do not put your hands in the
area of the drill while the power
tool is running. Upon contact with
the bit is a risk of injury.
• Never remove drilling chips from
the drilling area while the pow-
er tool is running. Always put the
drive mechanism in the standby positi-
• Do not remove accumulated drill
chips with your bare hands.
There is a risk of injury due to hot and
sharp metal shavings in particular.
Break up long drilling chips by
•
interrupting the drilling opera-
tion with a short backward ro-
tation of the rotary wheel. Long
drilling chips may cause injury.
• Keep handles dry, clean and
free from oil and grease. Greasy,
oily handles are slippery and lead to
loss of control.
• Use clamps to hold the workpie-
ce in place. Do not work on any
workpieces that are too small for
clamping. If you hold the workpiece by
ly against rotation and may hurt yourself.
• Switch the power tool off imme-
diately if the bit jams. The bit jams
when:
- the power tool is overloaded or
- the workpiece to be machined is
jammed.
• Do not touch the bit after wor-
king before it has cooled down.
The bit is very hot during use.
• Inspect the cable regularly and
have a damaged cable repaired
only by an authorised customer
service centre. Replace damaged
extension cables. This will ensure
that the power tool remains safe.
• Store unused power tools in a
safe place. The storage place
should be dry and lockable. This
prevents the power tool from being
damaged as a result of being stored or
operated by inexperienced people.
• Never leave the tool before it
has come to a complete stand-
still. After-running bits can cause inju-
ry.
M T
G B
-
6 1