Aigostar 8433325184926 Manual Del Usuario página 4

GB
ASSEMBLY OF CROSS STAND & COLUMN UNIT
1. Loosen 4 sets of screws, washers and spring washers which are fitted in the center section
on the stand and assembly the extension pole onto the base enclosure with these screws
originally. (Fig.1)
2. Loosen the height adjustment ring, lift the internal pole to the max height and prevent
the internal pole from slipping into the extension pole, then screw out the height
adjustment ring. (Fig.2)
3. To attach the stand ornament (cover for the stand), slide the stand ornament down
the extension pole. (Fig.3)
4. Reattach the height adjustment ring. (Fig.4)
5. From the extension pole loosen the height adjustment ring and adjust the internal pole
to the desired height. (Note: If you can't find the internal pole, it slides inside the
extension pole. You can pull it out from the extension pole.) (Fig.5)
6. To attach the head unit to the internal pole, loosen the thumb screw on the bottom of
the head unit. Place the head unit on the internal pole and tighten the thumb screw in
alignment with the groove on the internal pole. (Fig.6)
Fig.1 Fig.2
1
2
3
6
4
5
Fig.4 Fig.5
7 8
03
Fig.3
1.Fasten tight
2.Adjustment ring
3.Stand ornament
4. screws
5.Stand
6.Loosen
Fig.6
7.Tighten
8.Loosen
9
10
9.Annular groove
11
10.Thumb screw
11.Mounting hole
GRILL & FAN BLADE ASSEMBLY
1. Unscrew the spinner clockwise (or take the spinner out from the bag) and the plastic
nut counterclockwise to remove both of them. Fix the rear grill to the motor then
tighten the plastic nut again. (Fig. 7)
2. Insert the blade into shaft, and make sure the rotor shaft pin is fitted into groove of
the blade. Turn the spinner counterclockwise to tighten the blade. (Fig. 8)
3. Fasten the front grill and the rear grill by the grill clip and then tighten the fan grill
locking screw and nut. (Fig. 9)
5
1
9
2
3
4
Fig.7 Fig.8
6
1.Spinner 2.Tight 3.Loose
5.Spinner 6.Blade 7.Slot
OPERATING INSTRUCTION
1. Speed is controlled by the Piano switch:
0---Off 1---Low 2---Medium 3---High
2. To make/stop the fan head oscillate. Push down/pull up the clutch knob.
3. To adjust the air flow upward or downward, push the grilles lightly to the
desired direction.
4. The height of the fan can be adjusted by loosening the height adjustment ring,
carefully raising or lowering the fan and firmly re-tightening the height
adjustment ring.
GB
7
8
Fig.9
4.Plastic nut
8.Remaining Pin 9.Tight
04