Helpful Tips - Nostalgia Products IGLOO IWCBL5OSCEC1CHBKS Instrucciones Y Recetas

Dispensador auto-limpiante de agua caliente y fría con carga inferior
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1.
Place bottle, glass, or pitcher below the water tap.
2.
Push the cold or room temperature water button
downward to start dispensing water.
3.
Release the button once the desired fill
level is achieved.
Dispensing Hot Water
After setup, it will not take long to reach maximum
hottest temperature. NOTE: For safety, there
is a lock on the dispensing button.
1.
Place bottle, glass, pitcher, pot below the hot water tap.
2.
Release child-safety lock by pushing inward on the red button while pushing the
hot water button downward at the same time to start dispensing water.
3.
Release the button once desired fill level is achieved.
WARNING: Be careful when dispensing hot water as temperature can reach 200 °F.
Self-Cleaning Mode
The unit's self-cleaning feature prevents the formation of Biofilm. The
self-cleaning feature is not intended for water purification.
When the LED light is flashing it indicates that the self cleaning takes place. When
the LED light is constantly lit it indicates that the self clean protection is on.
NOTE: Self cleaning works every four hours for a short time.
The selfcleaning pump sound is normal.
Replacing An Empty Bottle/Low Water Indicator lights
When your water bottle is empty, the EMPTY BOTTLE lights will blink until a fresh bottle is
installed. You may also hear a sucking sound when the bottle is empty and needs changing. This
is normal and is another way to be alerted that your bottle is empty and needs to be replaced.
To install a new bottle:
1.
Open the door and slide the bottle out.
2.
Place the fresh bottle in front of the tray.
3.
Clean the fresh bottle using a soft cloth and warm soapy water.
4.
Remove the entire plastic cap from the top of the bottle.
5.
Remove probe from old bottle and insert into the fresh bottle.
6.
Push the probe down until it is seated.
7.
Slide the bottle onto the tray and close the door completely.

HELPFUL TIPS

Do the LED lights use a lot of electricity?
No. LED lights are known for being energy efficient and consume very little energy.
I can't find the rectangular bottles? What other kind of bottles does the cooler take?
The cooler will accept any standard three or a five gallon water bottle, circular or
rectangular.
8

Publicidad

Tabla de contenido
loading

Tabla de contenido