How To Operate - Nostalgia Products IGLOO IWCBL5OSCEC1CHBKS Instrucciones Y Recetas

ASSEMBLY
Use EXTREME CAUTION when handling the appliance. When taking out of
package, it is recommended to lay the box safely on its side. For the most part,
the HOT & COLD WATER BOTTOM LOAD WATER COOLER is assembled. Once
unpacked and standing up right, the drip tray will need to be inserted.
Location Requirements:
1. Install in the area where it is protected from the elements including direct sun.
2. Install and use only on a hard, flat and level surface.
3. Do NOT place the dispenser inside an enclosed space or cabinet.
4. Position the dispenser no closer than 4 inches from the wall with at
least 4 inches clearance on the sides to permit free airflow.
5. Service should only be performed by a certified technician.
WATER COOLERS
It is very easy to replace 3 or 5 gallon coolers (not included). NOTE:
Excessive weight hazard - It is recommended to use two or more people
to move and install bottles. Failure to do so can result in injury.
1. Open up the cabinet door on the bottom and take the water cap off the water cooler.
2. Place the siphon pump inside of the water jug so it's touching the bottom.
3. Make sure the siphon pump cover cap fits securely over
the water jug top, ensuring no leakage.
NOTE: The siphone pump is adjustable. Adjust the length by pulling the
portion of the tube to its maximum extension. Insert the probe into the bottle
and push it down. The probe will self-adjust to its appropriate length.
4. Close the door.

HOW TO OPERATE

WARNING: This unit is intended for water dispensing only. Do NOT use
other liquids. Do NOT use for other purposes. Warranty is void if used
with any other liquids such as coffee, tea, juices, beer or wine.
This dispenser has been designed to use water bottles with a 3
or 5 gallon capacity. Do NOT use alternative bottles.
Initial Set Up
NOTE: Make sure that switches are ON. Both the Hot and Cold water, and
LED light switches are located in the back of the water cooler.
1. Remove the tamper seal from bottle cap and remove the cap.
2. Place the siphon pump inside the water cooler and make sure
cap is on securely and place inside water cooler door.
Plug the cord into a properly grounded wall outlet. WARNING:
3.
Always make sure that the cord is away from a water source.
Dispensing Cold & Room Temperature Water
After setup, it will take up to one hour to get the water to its maximum cold temperature.
7