Installing The Filter Cartridge; Using The Appliance - Philips WP3861 Manual De Instrucciones

English
10
 Screw the attachment nut firmly onto the water purifier
housing (Fig. 21).
Make sure the rubber washer is firmly pushed against the tap to prevent
water leakage.

Installing the filter cartridge

1 Make sure the tap is closed.
 Set the water selection lever to the unfiltered stream
position (Fig. 22).
3 Tilt the filter cartridge holder 90° backwards and insert it into the
water purifier housing (Fig. 23).
 Pull the cartridge holder upwards until it is in upright
position. (Fig. 24)

using the appliance

1 Make sure that the water purifier housing and the filter cartridge
holder are properly installed.
 Turn the water selection lever to the desired setting ('click').
Filtered spray
Select this setting for drinking, washing vegetables or fruits and
for cooking.
Tip:We advise you to boil the filtered water before you drink it.
1 Turn the water selection lever until the filtered spray symbol is
aligned with the indicator (Fig. 25).
Do not let water hotter than 50°C run through the water purifier at
this setting, as this may damage the water purifier.
If you filter water between 35°C and 50°C, the water may have an
unpleasant smell. The filter cartridge has absorbed this smell during
filtering, but releases it again if you filter water hotter than 35°C.
4222.002.6611.2.indd 10 06-09-2006 14:34:26