Powerreclinexr Assembly Instructions - LAZBOY PowerReclineXR Instrucciones De Operación

PowerReclineXR
Assembly Instructions
NOTICE:
Do not plug in until instructed.
1. Carefully cut the plastic tie holding the power transformer box and the hand wand to the
body bracket (F 1).
IGURE
2. Remove the power transformer from the box and the hand wand from the bubble wrap.
Lay the hand wand on the seat.
WARNING
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
3. Install the back.
Lay the back across the arms of the chair. Lift the back at a slight angle and align the brackets on
•
the back with the brackets on the body (F
• Lower the back onto the body, making sure the back and body brackets are completely engaged.
To make sure the back is properly installed with both sets of back and body brackets
-
engaged, stand behind the chair and twist the back from side to side. If one or both sides
move out of position the brackets are not engaged (F
the steps above.
If you are unable to install the back properly, contact your La-Z-Boy
-
Lock the brackets by using a screwdriver to push down the locking levers (F
•
4. Locate the power supply connector behind the chair. Connect the power transformer connector to
the power supply connector. Close the locking cover to secure the connection (F
5. Connect the 120 volt power cord to the power transformer (F
instructed in the operating instructions.
6. If assembling a PowerReclineXR TM Rocking Loveseat, proceed to the PowerReclineXR
Rocking Loveseat Assembly Instructions.
7. If assembling a PowerReclineXR TM chair, proceed to the Battery Backup Assembly Instructions.
8. To remove the backs, unplug the 120 volt power cord from the electrical outlet, and
disconnect the power transformer connector from the power supply connector. Reverse
the Assembly Instructions steps.
6
™
2)
IGURE
3). Remove the back and repeat
IGURE
® dealer for assistance.
4).
IGURE
5).
IGURE
6). Do not plug in until
IGURE
TM
PowerReclineXR
Assembly Instructions
F 1
IGURE
Hand Plastic Power
Wand Tie Transformer Box
F 3
IGURE
Back and body brackets on this
side are not engaged. Remove
the back and reinstall.
F 5
IGURE
Power Supply Connector
Make this
connection
Power
Transformer
™
F 2
IGURE
Body
Bracket
Back Bracket
F 4
IGURE
Back
Locking
Bracket
Lever
Locked
Position
F 6
IGURE
Make this
connection
120 Volt Power
Power Cord Transformer
7