Bosch ALR 900 Manual Original página 14

Ocultar thumbs Ver también para ALR 900:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 28
OBJ_BUCH-835-005.book Page 14 Wednesday, September 28, 2016 6:13 PM
14 | English
H05RN-F types or IEC type design
(60227 IEC 53, 60245 IEC 57).
If you want to use an extension cable
when operating your product, only the
following cable dimensions should be
used:
2
– 1.0 mm
: max. length 40 m
2
– 1.5 mm
: max. length 60 m
2
– 2.5 mm
: max. length 100 m
Note: If an extension cable is used it
must be earthed and connected
through the plug to the earth cable of
your supply network in accordance
with prescribed safety regulations.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service Cen-
tre.
WARNING! Inadequate extension
cables can be dangerous. Exten-
sion cable, plug and socket must be
of watertight construction and in-
tended for outdoor use.
Cable connections should be kept dry
and off the ground.
It is recommended for increased elec-
trical safety to use a Residual Current
Device (RCD) with a tripping current of
not more than 30 mA. Always check
your RCD every time you use it.
The connection lead must be inspected
for signs of damage at regular intervals
and may only be used if in perfect con-
dition.
If the supply cord is damaged, it must
be replaced by a Bosch Service Centre.
For products not sold in GB:
WARNING: For your safety, it is re-
quired that the plug attached to the ma-
chine is connected with the extension
F 016 L81 483 | (28.9.16)
cord. The coupling of the extension
cord must be protected against splash
water, be made of rubber or coated
with rubber. The extension cord must
be used with a cable strain relief.
Products sold in GB only: Your prod-
uct is fitted with a BS 1363/A approved
electric plug with internal fuse (ASTA
approved to BS 1362).
If the plug is not suitable for your socket
outlets, it should be cut off and an ap-
propriate plug fitted in its place by an
authorised customer service agent.
The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of
to avoid a possible shock hazard and
should never be inserted into a mains
socket elsewhere.
Products sold in AUS and NZ only:
Use a residual current device (RCD)
with a rated residual current of 30 mA
or less.
Maintenance
Keep all nuts, bolts and screws tight
to be sure that the machine is in safe
working condition.
Check the grassbox frequently for
wear or deterioration.
Examine the machine and replace
worn or damaged parts for safety.
Ensure replacement parts fitted are
Bosch approved.
Always wear gardening gloves when
handling or working near the sharp
tines/blade.
Bosch Power Tools

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Avr 1100Avr 9003 600 h8a 03 600 h8a 1

Tabla de contenido