Function Introduction For Combination Buttons - d2itsu DS-9UIDN Manual De Instrucciones

Introduction for buttons on remote controller
7
Temp button
Press this button, you can see indoor set temperature, indoor ambient temperature
on indoor unit's display. The setting on remote controller is selected circularly as below:
Note:
● Outdoor temperature display is not available for some models. At that time, indoor
unit receives "
8
Turbo button
Press this button to activate / deactivate the Turbo function.
9
button
Press this button to achieve the on and off of healthy and scavenging functions in
LCD displays "
scavenging functions simultaneously; LCD displays "
button for the third time to quit healthy and scavenging functions simultaneously.
Press the button for the fourth t ime to start healthy function; LCD display "
Press this button again to repeat the operation above.
● This function is applicable to partial of models.
10
Timer button
● Under ON status, press this button to set timer OFF; Under OFF status, press
this button to set timer ON.
● Press this button once and the characters of HOUR ON (OFF) will flash to be
displayed. Meanwhile, press " " button or " " button to adjust timer setting (time
will change quickly if holding " " or " " button). Time setting range is 0.5~24hours.
Press this button again to confirm timer setting and the characters of HOUR ON
(OFF)will stop flashing.
If the characters are flashing but you haven't press timer button,timer setting
status will be quit after 5s.If timer is confirmer, press this button again to cancel timer.
11
X-Fan button
Press this button in COOL or DRY mode to turn on X-fan function.
When this function is started up, indoor fan will still operate at low fan speed for a
while after turning off the unit by remote controller.
12
Light button
Press this button to
off the display's
light.

Function introduction for combination buttons

Combination of " " and " " buttons: About lock
Press " " and "
▲
controller is locked,
three times.
no display
" signal, while it displays indoor set temperature.
". Press the button for the second time to start healthy and
▲
▲
turn on the display's light and press this button again to turn
▲
" buttons simultaneously 3s to lock or unlock the keypad. If the remote
is displayed. In this case, pressing any button,
" and "
9
". Press this
".
blinks