Replacement Of Batteries In Remote Controller - d2itsu DS-9UIDN Manual De Instrucciones

Function introduction for combination buttons
Combination of "MODE" and " " buttons:
About switch between Fahrenheit and centigrade
At unit OFF, press "MODE" and "
Combination of "TEMP" and "TIMER" buttons:
About Energy-saving Function
Press "TEMP" and "TIMER" simultaneously in COOL mode to start e nergy-saving function.
Nixie tube on the remote controller displays "SE". Repeat the operation to quit the function.
Combination of "TEMP" and "TIMER" buttons:
About 8 ℃ Heating Function
Press "TEMP" and "TIMER" simultaneously in HEAT mode to start 8℃ Heating Function
Nixie tube on the remote controller displays "
(46℉ if Fahrenheit is adopted). Repeat the operation to quit the function.
WIFI Function
Press "MODE" and "TURBO" button simultaneously to turn on or turn off WIFI
function. When WIFI function is turned on, the "
remote controller; Long press "MODE" and "TURBO" buttons simultaneously for
10s, remote controller will send WIFI reset code and then the WIFI function will be
turned on. WIFI function is defaulted ON after energization of the remote controller.
● This function is only available for some models.

Replacement of batteries in remote controller

1. Press the back side of remote controller marked
the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
3. Reinstall the cover of battery box.
" buttons simultaneously to switch between ℃ and ℉.
" and a selected temperature of "8℃".
10
" icon will be displayed on
signal sender battery
reinstall
remove
Cover of battery box