Publicidad
Idiomas disponibles
Idiomas disponibles
If the dryer stops, the status lights flash and the signal beeps, an error has occured. Press PAUSE/CANCEL. Consult the Error Code Chart below or the "Avoid Service Checklist" in the
Owner's Guide for the possible cause and solution. Make correction, then select a cycle and press START. If the dryer stops, status lights flash again and the beeping continues, please
contact service for assistance.
Error Code
4 beeps
6 beeps
Towels
Estimated Cycle
60 minutes
Duration ***
Temperatures
High
Medium
Low
No Heat
not recommended not recommended not recommended not recommended
Dryness Level
*
More Dry
Normal Dry
Less Dry
Damp Dry
Options
Soft Heat
Wrinkle Rid
*
Cycle Signal
Available settings
* Factory setting
Error
Dryer ran too long
Push button does not function
DRYER SETTINGS CHART
These temperatures, dryness levels and options are available with the following cycles:
Normal
Perm Press
50 minutes
40 minutes
*
*
** Timed Dry Cycle Only
ERROR CODE CHART
Possible Causes
Lint filter blocked. Ventilation system clogged.
Dryer overloaded.
Push button held too long or wedged in the
control panel.
Delicate
20 minutes
*
*
*
*
*
*
*
*
*** Estimated cycle duration is based on normal
dryness level and factory settings.
Solutions
Remove lint; wash lint filter to remove
softener sheet residue Clean out ventilation
system. Reduce load size.
Press buttons lightly and release. Disengage
button.
Quick
Touch Up
**
**
recommended
*
*
PN 134463900C (0412)
Timed Dry
**
*
Publicidad
