Publicidad
EN
A - Carrying handle
B
- XL Sun canopy (built-in)
C
- Push button for carrying handle
adjustment (L+R)
D - Stroller release buttons (L+R)
E
- Belt hooks for lap part of belt (L+R)
F
- Soft carrier release buttons + locking
indicators (L+R)
G
- Safety shell
H - Soft carrier
H1 - Cover
H2 - Baby-hugg inlay
H3 - Shoulder belts with removable belt pads
H4 - Crotch strap with belt buckle & removable
crotch pad
H5 - Harness adjuster button
H6 - Soft carrier locking axle
H7 - Belt tensioner strap
H8 - Retractable soft carrier handles (L+R)
I
- Soft carrier locking hooks (L+R)
J1 - Belt hook for shoulder part of belt
J2 - Instruction manual storage
J3 - Mounting bars for base
SAFETY
The car seat is developed for an intensive use of
approximately 6 years.
Coral car use
• Only use a forward-facing seat that is fitted with a
3-point safety belt that complies with the ECE R16
standard.
• Make sure the car safety belt buckle runs in a straight
line and stays below the belt hook of the car seat.
• The car safety belt must be threaded tight along all
green markings. For a proper installation, check the
instruction in this manual and the sticker on the side of
the car seat.
WARNING:
• Install the car seat only rearward facing in the car on a
forward facing vehicle seat.
I
48
Coral I Bébé Confort
Coral and your baby
• Make sure you can fit no more than one finger
between the harness and your baby (1cm). If there is
more space than 1 cm, tighten the harness belt further.
• Only use the baby-hugg inlay of the Coral until your
baby exceeds the 60 cm length limit. Afterwards
remove the baby-hugg inlay from the Coral.
WARNING:
• Never place the car seat and/or the soft carrier on an
elevated surface (such as a table or chair).
• In order to prevent the car seat from tipping over
during carrying, check if the carrying handle is locked in
place in carrying position (A1).
• When Coral is installed on a stroller, always make sure
to use approved car seat adapters and to secure Coral
correctly.
Using the soft carrier
• Fold the carrying handle down and take both soft
carrier handles from the sides and hold them together
in one hand.
• Press the soft carrier release button on the side of the
safety shell in order to unlock the soft carrier.
• Lift up the soft carrier from the safety shell.
When placing the soft carrier back in the safety shell,
make sure it locks by means of an audible 'Click'.
• The soft carrier handles will automatically retract
when released.
• Put the carrying handle in the most forward position
towards the baby's legs until it locks (position A1).
WARNING:
• Always check if the indicator on the carrier release
buttons have turned green. If not, push the soft carrier
further into the safety shell until it locks by means of an
audible 'Click' and the indicators on the side turn green.
• Before using the soft carrier to carry your baby,
always make sure that your baby is strapped correctly
with the integrated harness system. Never carry your
baby unstrapped in the soft carrier.
• Make sure the carrying handle is in position A1.
• The soft carrier cannot and may never be installed
as stand-alone in a car. It must always be locked in the
safety shell.
Publicidad
