MTD Bolens BL100 Manual De Operador página 18

CUTTING ATTACHMENT WILL NOT ADVANCE LINE
CAUSE
Cutting attachment bound with grass
Cutting attachment out of line
Inner reel bound up
Cutting head dirty
Line welded
Line twisted when refilled
Not enough line is exposed
CUTTING LINE ADVANCES UNCONTROLLABLY
CAUSE
Oil, cleaner or lubricant in cutting head
If further assistance is required, contact your authorized service dealer.
18
TROUBLESHOOTING
Stop the engine and clean cutting
attachment
Refill with new line
Replace the inner reel
Clean inner reel and outer spool
Disassemble, remove the welded section
and rewind
Disassemble and rewind the line
Push the bump knob and pull out line until
4 inches (102 mm) of line is outside of the
cutting attachment
Clean and thoroughly dry the cutting head
ACTION
ACTION