Publicidad
EN
Installation
The WS-20's tamper switch is disabled by default so the switch does
not get triggered during installation. Once your WS-20 is properly
installed, you then can enable the tamper switch in your WS-20's
settings page in your smanos home app.
1. Set the positioning paper on the wall and place the leveler on the
paper. Adjust accordingly for correct alignment.
2. Install the two screws into the top screw holes.
3. Mount the bracket into the bottom screw holes and tighten it
with the screws.
4. Tear off the positioning paper.
5. Mount the siren to the wall and tighten the screws.
Gradienter
Positioning
paper
Removing the WS-20 from your K1/K2 Hub
You can remove your WS-20 by navigating to the accessories page
on your smanos home app of the selected hub. Then, slide your
finger over the WS-20 from right to left. Tap on the trash bin icon to
remove the WS-20 from your hub.
Specifications
Model:
WS-20
Battery:
1.5V LR14 Size battery x4pcs
Static Current:
≤ 15mA
Alarm Current:
≤ 350mA
Transmitting Distance:
≤ 80m/262.5ft (Open area)
Maximum Siren Volume:
105 dB
Radio Frequency:
868MHz or 915MHz
*Only 868 MHz is available for Europe
Housing Material:
PC+ABS plastic, ANTI-UV
IP Rating:
IP55
Operation Condition:
Temperature: -20°C to +50°C (-4°F to +122°F)
Relative Humidity: <95% RH(non-condensing)
Dimensions (L x W x H):
157.5 X 70 X 20.7 mm
EN
Publicidad
